Case 2, Stage support
Top Left: spare cables, Top Center, Body pack Tx in case, Right: Charger bays
Lower Left: Charger power supplies (must use both), backup whip anetennas
Top Center: BNC and 8pr XLR snake
Right: empty pouches under HH Tx, caps towards handle
Left: Diversity Fin, label out and upright
Right, additional empty shure pouches for padding
Case 3, FOH Support
Left: White foam insert, Right: Laptop
Left: MOTU in pink foam sleeve, connections to left, face to right with gray foam on face.
Shure Case: Q Widget, USB C Hub, USB C-B, USB A-B, Mini-XLR, Midi
FOH setup intention- 15′ AC supplies power from a single house outlet, supplies laptop power unit and MOTU DC power unit.
Laptop connections are Magsafe for power, usb C-B from laptop to MOTU for a direct connection, usb A-B for Q-Widget through usb C hub. If the magsafe cable is not supplying power for any reason, the spare usb C cable can be plugged into the hub and the hub will pass the power through to the laptop. The hub also has RJ-45 ethernet to connect to the wireless rig for configuration. Network cables are in the rack case. Plug into the top unit and you should see both in Wireless Workbench.
John, I think you mentioned usually have an A2 managing RF and coordination fo ryou, so ehre’s a Basic RF scan and deploy video: https://youtu.be/FlVaP-IVivo?si=hO5n35AkSRTpob0e
You will still have to sync all transmitters after the receivers have been coordinated. Be sure all battery types are set to Lithium, otherwise the battery metering will not be accurate. The charging bays will need both DC power supplies if you are charging more than 6 batteries in the 8 bays- if not, there will not be enough power and you will get errors and the batteries won’t charge.
Right next to Motu: Shure Case towards back, Laptop power and mouse towards front
Left: TRS-XLR snake, board tape and sharpie, Right: 15′ AC w/ tri-tap end for FOH power, Laptop power cables (Edison power to supply brick, magsafe for laptop, courtesy lightning cable), Motu DC power supply.